
New TopShim run:

version = topshim 2.0.0
date = 2021-05-09
time = 21:10:54.084
command = topshim  fine h2o_1.7mm ordmax=5 shigemi

FINE SHIMMING

Parameters:

probe = Z150329_0015
solvent = 5%DMSOinH2O_1.7mm
shim nucleus = 1H
nucleus optimised for = 1H
o1p (set) = 4.59 ppm

Results:


1D Shimming:
Iteration  1: FWHM Before= 3.1 Hz, Target= 1.1 Hz, After= 2.1 Hz
Iteration  2: FWHM Before= 2.1 Hz, Target= 0.8 Hz, After= 2.1 Hz
Iteration  3: FWHM Before= 2.1 Hz, Target= 1.1 Hz, After= 0.2 Hz
Iteration  4: FWHM Before= 0.2 Hz, Target= 1.1 Hz, After= 1.2 Hz
Iteration  5: FWHM Before= 1.2 Hz, Target= 1.1 Hz, After= 2.0 Hz
Iteration  6: FWHM Before= 2.0 Hz, Target= 1.1 Hz, After= 1.1 Hz
Iteration  7: FWHM Before= 1.1 Hz, Target= 0.8 Hz, After= 2.2 Hz
Iteration  8: FWHM Before= 2.2 Hz, Target= 1.1 Hz, After= 0.2 Hz
Unusually slow convergence detected. Shimming was aborted.
Using the best result as the final shim state.

Lineshape quality factor (1D spectrum, spinning) = 1.58


Sample position (Shigemi) = -0.53 - 0.65 cm.

shim changes: 
Z	-127
Z2	+6
Z3	-268
Z4	-176
Z5	+1086

duration = 1 min 8 sec
completed successfully
finished Sun May  9 21:11:59 2021


========================================================================
