New TopShim run:

version = topshim 2.0.0
date = 2021-05-07
time = 14:42:33.183
command = topshim  fine h2o_1.7mm ordmax=5 shigemi

FINE SHIMMING

Parameters:

probe = Z150329_0015
solvent = 5%DMSOinH2O_1.7mm
shim nucleus = 1H
nucleus optimised for = 1H
o1p (set) = 4.59 ppm

Results:


1D Shimming:
Iteration  1: FWHM Before= 3.9 Hz, Target= 0.6 Hz, After= 5.0 Hz
Iteration  2: FWHM Before= 5.0 Hz, Target= 0.4 Hz, After= 2.9 Hz
Iteration  3: FWHM Before= 2.9 Hz, Target= 0.5 Hz, After= 2.3 Hz
Iteration  4: FWHM Before= 2.3 Hz, Target= 0.4 Hz, After= 5.4 Hz
Iteration  5: FWHM Before= 5.4 Hz, Target= 0.4 Hz, After= 6.9 Hz
Iteration  6: FWHM Before= 6.9 Hz, Target= 0.5 Hz, After= 3.7 Hz
Iteration  7: FWHM Before= 3.7 Hz, Target= 0.4 Hz, After= 1.7 Hz
Iteration  8: FWHM Before= 1.7 Hz, Target= 0.4 Hz, After= 0.6 Hz
Unusually slow convergence detected. Shimming was aborted.
Using the best result as the final shim state.

Lineshape quality factor (1D spectrum, spinning) = 1.07


Sample position (Shigemi) = -0.53 - 0.65 cm.

shim changes: 
Z	-4
Z2	+5
Z3	+20
Z4	-630
Z5	-1359

duration = 1 min 6 sec
completed successfully
finished Fri May  7 14:43:36 2021


========================================================================